Experimental and Numerical Investigation of Nanofluid Usage in A Plate Heat Exchanger for Performance Improvement


Creative Commons License

SÖZEN A., Khanlari A., ÇİFTÇİ E.

INTERNATIONAL JOURNAL OF RENEWABLE ENERGY DEVELOPMENT-IJRED, cilt.8, sa.1, ss.27-32, 2019 (ESCI) identifier identifier

  • Yayın Türü: Makale / Tam Makale
  • Cilt numarası: 8 Sayı: 1
  • Basım Tarihi: 2019
  • Doi Numarası: 10.14710/ijred.8.1.27-32
  • Dergi Adı: INTERNATIONAL JOURNAL OF RENEWABLE ENERGY DEVELOPMENT-IJRED
  • Derginin Tarandığı İndeksler: Emerging Sources Citation Index (ESCI), Scopus
  • Sayfa Sayıları: ss.27-32
  • Anahtar Kelimeler: Plate heat exchanger, Nanofluid, Heat transfer enhancement, Performance, Numerical analysis, MIXTURE, CHEVRON, FLOW
  • Gazi Üniversitesi Adresli: Evet

Özet

Plate heat exchangers, a compact-type heat exchanger, are commonly used heat transfer devices because of their superior characteristics. Their thermal performances are strongly dependent to working fluid circulating inside the system. The influences of nanofluid utilization as the working fluid in a plate heat exchanger was experimentally and numerically analysed in this study. In order to show off the improvement rate in heat transfer, the experiments were performed by using deionized water and TiO2-deionized water nanofluid. The nanofluid was prepared at the rate of 1.5 % as weighted. A surface-active agent, Triton X-100, was also doped into the mixture at the rate of 0.2% of a final concentration to prevent the sedimentation and flocculation of the nanoparticles inside the solution. The experiments were performed in different temperatures as 40 degrees C, 45 degrees C, 50 degrees C and varying cold fluid mass flow rates as 3,4, 5, 6 and 7 lpm. In addition, using the experimental data, a numerical simulation was realized by ANSYS Fluent software. The both results indicate that heat transfer rate in plate heat exchanger can be improved using nanofluid as the working fluid in place of deionized water. The maximum improvement rate in heat transfer was obtained as 11 % in experimental study. It is also seen that experimental and numerical results are in good agreement. (c) 2019. CBIORE-IJRED. All rights reserved