An experimental study on strengthening of masonry infilled RC frames using diagonal CFRP strips


ALTIN S., Anil Ö., Kara M. E., Kaya M.

Composites Part B: Engineering, cilt.39, sa.4, ss.680-693, 2008 (SCI-Expanded) identifier identifier

  • Yayın Türü: Makale / Tam Makale
  • Cilt numarası: 39 Sayı: 4
  • Basım Tarihi: 2008
  • Doi Numarası: 10.1016/j.compositesb.2007.06.001
  • Dergi Adı: Composites Part B: Engineering
  • Derginin Tarandığı İndeksler: Science Citation Index Expanded (SCI-EXPANDED), Scopus
  • Sayfa Sayıları: ss.680-693
  • Anahtar Kelimeler: carbon fibre, debonding, stress concentrations, brick masonry infills
  • Gazi Üniversitesi Adresli: Evet

Özet

The purpose of this study was to investigate experimentally the behavior of strengthened masonry infilled reinforced concrete (RC) frames using diagonal CFRP strips under cyclic loads. Ten test specimens were constructed and tested under cyclic lateral loading. Specimens were constructed as 1/3 scale, one-bay, one-storey perforated clay brick-infilled nonductile RC frames. The aspect ratio (lw/hw, where lw is the infill length and hw is the infill height) of masonry-infilled wall was 1.73. CFRP strips were applied with different widths and with three different arrangements such as on both sides (i.e. symmetrically) and on the interior side or the exterior side of the masonry walls. This experimental study investigated the effects of CFRP strips' width and arrangement type on specimens' behavior. Strength, stiffness and storey drifts of the test specimens were measured. Test results indicated that, CFRP strips significantly increased the lateral strength and stiffness of perforated clay brick infilled nonductile RC frames. Specimens receiving symmetrical strengthening showed higher lateral strength and stiffness. Specimens at which CFRP strips of the same width were applied to one of the interior or exterior surface of the infill wall showed similar lateral strength and stiffness. © 2007 Elsevier Ltd. All rights reserved.