Akademik Veri Yönetim Sistemi
MATERIALS CHEMISTRY AND PHYSICS, cilt.328, 2024 (SCI-Expanded)
This study focuses on the effects of theoretical volume fraction (TVF) on the microstructure and mechanical properties of silicon carbide (SiC) and zirconium diboride (ZrB2) ceramic reinforced Al5083 surface composites (SC). Al5083-H111 was used as the base material (BM), SiC and ZrB2 were used as reinforcement materials, and TVFs were determined as 5, 10, 15, and 20 % for SCs produced by the friction stirring process (FSP). Macrostructure, microstructure, X-ray diffraction (XRD) analysis and mechanical properties such as microhardness, tensile strength (UTS), and wear behaviour were characterised. When the TVF and AVF values of SiC and ZrB2 particles were compared, it was found that the AVFs were lower than the TVFs. Significant decreases in the changes in the SZ areas of SiC and ZrB2 particle SCs were detected depending on the reinforcement size. In the time-dependent axial load graphs of SiC and ZrB2 reinforced samples, load values ranging from 7800 to 8200 N were obtained and it was determined that these values were sufficient for friction heat, hydrostatic pressure, and plasticisation in FSP. As a result of mechanical characterisation processes, the microhardness values and wear rates of ZrB2 reinforced SCs in the stir zone (SZ) were higher than SiC reinforced SCs. When the reinforcement particles were compared, it was observed that ZrB2 reinforced SCs exhibited higher microhardness and wear resistance than SiC reinforced SCs. As a result of all tests and investigations, it was determined that the ideal TVFs were 15% for SiC reinforced SCs and 5% for ZrB2 reinforced SCs. The microhardness value of ZrB2 reinforced SC with 20 % TVF was 119.6 HV, while the UTS and volume loss values of ZrB2 reinforced SC with 5 % TVF were found to be the highest values with 305.86 MPa and 1.83 mm3, respectively. Compared to BM, these values showed significant improvements in mechanical test results, especially in wear behavior. The results obtained showed an improvement of 55 % in microhardness, 3.3 % in UTS values, and 309 % in wear behavior.