High temperature tribology of additively manufactured titanium alloys: A condition dependent review
MATERIALS TODAY COMMUNICATIONS, cilt.57, ss.1-18, 2026 (SCI-Expanded, Scopus)
- Yayın Türü: Makale / Tam Makale
- Cilt numarası: 57
- Basım Tarihi: 2026
- Doi Numarası: 10.1016/j.mtcomm.2026.116582
- Dergi Adı: MATERIALS TODAY COMMUNICATIONS
- Derginin Tarandığı İndeksler: Scopus, Science Citation Index Expanded (SCI-EXPANDED), Chemical Abstracts Core, Compendex, INSPEC
- Sayfa Sayıları: ss.1-18
- Açık Arşiv Koleksiyonu: AVESİS Açık Erişim Koleksiyonu
- Gazi Üniversitesi Adresli: Evet
Özet
Additively manufactured (AM) titanium alloys are increasingly considered for sliding components at elevated temperature, but published wear data are difficult to compare because test conditions differ widely. This review compiles dry sliding data from 20 elevated-temperature studies, identified following a PRISMA-informed procedure, and 13 room-temperature studies on L-PBF, EB-PBF, DED and WAAM material of commercially pure titanium, Ti-6Al-4V, near-α, β and γ-TiAl alloys, and compares them within each study after stratification by counterface and contact geometry. AM materials reached wear rates within about a factor of two of conventionally processed material, and room-temperature hardness did not consistently rank wear resistance. With increasing temperature, the specific wear rate increased, decreased or changed non-monotonically depending on counterface, contact configuration and load, while friction did not follow wear. TiO2 was the oxide most consistently identified in tribo-layers by phase analysis, and the presence of a tribo-layer did not consistently coincide with lower wear. Reported wear mechanisms did not follow fixed temperature boundaries. Recommendations for reporting test conditions, characterizing tribo-layers and measuring hot hardness are given.