Akademik Veri Yönetim Sistemi
Journal of Functional Biomaterials, cilt.17, sa.4, 2026 (SCI-Expanded, Scopus)
The surface characteristics of zirconia may influence both soft tissue response and bacterial colonization. This study evaluated the surface roughness and water contact angle of zirconia fabricated by additive manufacturing (material jetting, NPJ) and subtractive manufacturing (milling), and investigated human gingival fibroblast (HGF-1) viability and Streptococcus mutans (S. mutans) (ATCC 25175) adherence on these surfaces, as well as the possible correlation between roughness and bacterial adhesion. Sixty-four zirconia specimens (1 × 1 × 0.1 cm) were fabricated (n = 32 per group), sintered, and standardized by abrasive polishing. Surface roughness and contact angle were measured. Cell viability was assessed using an MTT assay at 24, 48, and 72 h. Bacterial adhesion was quantified after 24 and 48 h of incubation. Data were analyzed using two-way ANOVA, independent t-tests, and Pearson correlation (α = 0.05). No significant differences in HGF-1 viability were observed at 24 and 48 h; however, at 72 h, subtractively manufactured zirconia demonstrated higher cell viability than additively manufactured specimens (p < 0.001). S. mutans adhesion was significantly greater on additively manufactured zirconia at 24 h (p = 0.002), with no significant difference at 48 h. Manufacturing technique influenced surface properties and early bacterial adhesion. Both materials exhibited acceptable biocompatibility within the tested conditions.