The cutting power, specific cutting energy and surface roughness characterization in milling of 8740 steel AISI 8740 çeliǧinin frezelenmesinde kesme gücü, özgül kesme enerjisi ve yüzey pürüzlülüǧü karakteristiklerinin belirlenmesi

---

Atıf İçin Kopyala

Özerkan H. B., Sucularli F., Genç A.

Journal of the Faculty of Engineering and Architecture of Gazi University, cilt.37, sa.4, ss.2057-2066, 2022 (SCI-Expanded)

• Yayın Türü: Makale / Tam Makale
• Cilt numarası: 37 Sayı: 4
• Basım Tarihi: 2022
• Doi Numarası: 10.17341/gazimmfd.948426
• Dergi Adı: Journal of the Faculty of Engineering and Architecture of Gazi University
• Derginin Tarandığı İndeksler: Science Citation Index Expanded (SCI-EXPANDED), Scopus, Academic Search Premier, Art Source, Compendex, TR DİZİN (ULAKBİM)
• Sayfa Sayıları: ss.2057-2066
• Anahtar Kelimeler: AISI 8740 steel, Up and down milling, Cutting power, Specific cutting energy, Surface roughness, CONSUMPTION, PARAMETERS, OPTIMIZATION, MODELS, SELECTION, IMPACT
• Gazi Üniversitesi Adresli: Evet

Özet

© 2022 Gazi Universitesi Muhendislik-Mimarlik. All rights reserved.In this study, the machining characterization properties (namely, cutting power Pc, specific cutting energy ps and surface roughness Ra) of AISI 8740 steel, which is used in high strength applications in the industry but do not have information about its machining characteristics in literature, were found experimentally for different machining parameters (feed per tooth (uncut chip thickness) fz and up- and-down-milling processes). The electric current measurements taken during non-cutting (idle) and cutting conditions were used in power calculations under different machining conditions. It was found that the ps decreased and Ra increased with increasing fz in the up-and down-milling operations and the lower Pc, ps and Ra values were obtained in down-milling than the up-milling operations. The ps values of the material was in between 7.1- 15.7 Ws/mm3 for the machining settings used in this study.