Determination of adsorptive and catalytic properties of copper, silver and iron contain titanium-pillared bentonite for the removal bisphenol A from aqueous solution


Tomul F., Turgut Başoğlu F., Canbay H.

APPLIED SURFACE SCIENCE, vol.360, pp.579-593, 2016 (SCI-Expanded) identifier identifier

  • Publication Type: Article / Article
  • Volume: 360
  • Publication Date: 2016
  • Doi Number: 10.1016/j.apsusc.2015.10.228
  • Journal Name: APPLIED SURFACE SCIENCE
  • Journal Indexes: Science Citation Index Expanded (SCI-EXPANDED), Scopus
  • Page Numbers: pp.579-593
  • Keywords: Ti-pillared bentonite, Copper, Silver and iron, Impregnation, Ion exchange, Direct synthesis, Surface characteristics, Acidity, Adsorption, Catalytic wet peroxide oxidation, WET PEROXIDE OXIDATION, PHOTOCATALYTIC DEGRADATION, MONTMORILLONITE CLAY, ELEMENTAL MERCURY, WASTE-WATER, NO, REDUCTION, TI, CO, ALUMINA
  • Gazi University Affiliated: Yes

Abstract

Tipillared bentonite, Cu, Ag and Fe modified Ti-pillared bentonite and Cu/Ti-and Fe/Ti-mixed pillared bentonite were synthesized using different titanium sources by direct synthesis or by modification after synthesis. The effects of synthesis conditions on the surface characteristics, pore structure and acidity of the pillared bentonites were investigated by SEM-EDS, XPS, XRD, N-2-adsorption/desorption and FTIR analyses before and after ammonia adsorption. The results of EDS, XPS and XRD analysis confirmed that titanium, copper, silver and iron were incorporated into the bentonite structure. In the XRD patterns, the formation of delaminated structure reflecting the non-parallel distribution of the bentonite layers by pillaring with Ti, Cu/Ti and Fe/Ti-pillars was observed. XPS spectra indicated the presence of TiO2, CuO, Ag and Ag2O and Fe2O3 species depending on the source of active metals in the synthesized samples. In the FTIR spectra, an increase in the Bronsted/Lewis peak intensity was observed with the loading of copper and iron, whereas a decrease in Lewis and Bronsted acidities was observed with incorporation of silver. Adsorption studies indicated that the adsorption capacity of the sample synthesized using titanium (IV) propoxide and incorporating iron to the structure by ion exchange (Fe-PTi-PILC) were higher than those in other samples. The adsorption of BPA (bisphenol A) by all tested samples was found to fit the Langmuir isotherm. In the catalytic wet peroxide oxidation (CWPO) over PTi-PILC (prepared by titanium (IV) propoxide), Fe-PTi-PILC and Cu-PTi-PILC (prepared by copper impregnated Ti-pillared bentonite) samples, BPA values close to complete conversion were achieved within 30 min at 25 degrees C, pH 4 and 5 g/L m(cat). CWPO results showed that increasement of pH causes a decrease the rate of oxidation. On the other hand, by the time catalyst and BPA concentration is increased, the rate of oxidation is increased as well. (C) 2015 Elsevier B.V. All rights reserved.