Evaluation of Electric and Dielectric Properties of Metal-Semiconductor Structures With 2% GC-Doped-(Ca3Co4Ga0.001Ox) Interlayer


MARIL E., TAN S. O., ALTINDAL Ş., USLU İ.

IEEE TRANSACTIONS ON ELECTRON DEVICES, cilt.65, sa.9, ss.3901-3908, 2018 (SCI-Expanded) identifier identifier

  • Yayın Türü: Makale / Tam Makale
  • Cilt numarası: 65 Sayı: 9
  • Basım Tarihi: 2018
  • Doi Numarası: 10.1109/ted.2018.2859907
  • Dergi Adı: IEEE TRANSACTIONS ON ELECTRON DEVICES
  • Derginin Tarandığı İndeksler: Science Citation Index Expanded (SCI-EXPANDED), Scopus
  • Sayfa Sayıları: ss.3901-3908
  • Anahtar Kelimeler: Dielectric properties, electrical properties, graphene, nanostructures, polymer, NANOCERAMIC/N-SI CAPACITORS, INTERFACIAL LAYER, AC CONDUCTIVITY, RELAXATION, GRAPHENE, POLARIZATION, SPECTROSCOPY, TEMPERATURE, DIODES
  • Gazi Üniversitesi Adresli: Evet

Özet

Electrical and dielectric properties of Au/n-Si metal-semiconductor structures with high dielectric have been examined by capacitance/conductance-voltage (C/G-V) measurements in the frequency range of 5-500 kHz at room temperature. Voltage-dependent profiles of interface states (N-ss) and resistance (R-i) were extracted from the C and G data using the low-high-frequency capacitance and Nicollian-Brews methods, respectively. The real and imaginary components of the complex dielectric constant (epsilon', epsilon ''), electric modulus (M' and M ''), and ac conductivity (sigma(ac)) were calculated from the C and G data. All parameters have a strong relation with frequency and voltage, especially at low frequencies due to Maxwell-Wagner relaxation and N-ss. The observed peaks in the N-ss-V and R-i-V plots can be ascribed by the special distribution of N-ss at M/S interface. These results confirmed that [2% graphene cobalt-doped (Ca3CO4Ga0.001Ox] interlayer has high-dielectric constant and can be used an interlayer instead of the traditional SiO2 at M/S interface to increase their capacitance or more charges/energy storage and reduce both the values of N-ss and series resistance (R-s). The values of a are almost constant at lower-intermediate frequencies, but they start to increase at high frequencies that are corresponding to the dc and ac conductivity, respectively.